FireAcad-Repair-Steps

FireAcad Repair Steps


Follow the steps below and you should be able to successfully repair FireAcad software.

 
 

FireAcad Repair Startup

When FireAcad Disk is inserted, the AutoPlay Dialog will pop up prompting to select run setup.exe

FireAcad Trigger Path

FireAcad trigger file path dialog will appear telling where the facadtrigger folder default location will be created. Leave the path as default and press OK button to proceed.

FireAcad Converstion Tool

FireAcad Conversion tool dialog will only appear if the user is changing their USB MPI lock to a USB 64 bit Lock.

FireAcad Conversion Success

Once you have successfully changed your USB MPI lock to a USB 64 bit Lock, FireAcad Conversion message will appear. Make sure to press OK and then Press Exit button to proceed on.

 
 
 

FireAcad Repair

This is the FireAcad main installation dialog. Please choose REPAIR button on the bottom right.

 
 

FireAcad Transfer

Files are being transferred and at the same time, replacing your existing files to the original files.

 
 
 

FireAcad Repair Finish

This dialog shows you have successfully repaired FireAcad on your computer. You will then be able to run FireAcad properly.